Mike,
I looked at their web page and the model I looked at indicated that it
supported Icom.
The RigBlaster will need to emulate a Com port that you assign to CT. If you
are sure the RigBlaster setup is correct, try another program that can
interface to the Icom to see if the results are different.
John, K3CT
----- Original Message -----
From: "Mike Smith" <sonicpepsi@gmail.com>
To: <ct-user@contesting.com>
Sent: Monday, January 21, 2008 11:38 PM
Subject: [ct-user] Flow Control for IC-706MKIIG
> All,
> Looking to setup CT for Win using a USB cable from my RIGblaster
> device that was sent with the radio from eBay. Not sure if this is
> possible but I am able to detect the radio and use the drivers that
> came with the cable to install.
> Each time I try to connect with CT, I receive a message ICOM radio not
> echoing.
>
> I looked as far back at 2001 but didn't see anything on the 706, but I
> could have missed something.
>
> Thanks in advance
> _______________________________________________
> CT-User mailing list
> CT-User@contesting.com
> http://lists.contesting.com/mailman/listinfo/ct-user
> CT on the web: http://www.k1ea.com/
_______________________________________________
CT-User mailing list
CT-User@contesting.com
http://lists.contesting.com/mailman/listinfo/ct-user
CT on the web: http://www.k1ea.com/
|