Here's a note from N5IN back in Y2K:
> Immediately
> after COMTSR for COM1 starts the radio goes into key down mode. And it
> stays in key down mode until CT loads, starts, gets to the final
> screen--then you must hit one of the CW function keys to send something.
> Only then does the key down condition clear.
So, it seems that you can wait until CT loads fully, then press an F-Key and
it should clear out.
73,
Bob W5OV
-----Original Message-----
From: AK [mailto:K4YKZ@ARRL.NET]
Sent: Tuesday, January 22, 2008 11:00 AM
To: ct-user@contesting.com
Subject: [ct-user] TSR Help needed for CT 10 user
I am running CT10 (CT8 upgrade) and use COM 1 as my interface to my IC756P3
for band settings and mode.
The same cable is used with MixW for PSK & RTTY operation, and DTR is used
to switch the interface relay between receive to transmit mode.
CT10 sets the DTR signal on at all times. This keeps the transmitter in
transmit mode, unless I unplug the DTR signal to my RIGblaster interface
relay.
It sure would be nice if my initialization TSR for the CT contest logging
would just keep DTR turned off.
I have played with "-DTR" for comtsr1 in my CT initialization batch file,
but have had no luck in turning DTR off.
Any suggestions?? Andy K4YKZ
-------------------------------------------
My present batch-file serial communications port TSR command is:
comtsr1 -b1200 -P1 -I4 -A3f8
_______________________________________________
CT-User mailing list
CT-User@contesting.com
http://lists.contesting.com/mailman/listinfo/ct-user
CT on the web: http://www.k1ea.com/
_______________________________________________
CT-User mailing list
CT-User@contesting.com
http://lists.contesting.com/mailman/listinfo/ct-user
CT on the web: http://www.k1ea.com/
|