The OMNI-VI likes to see 2400 baud. Make sure the address is correct and
experiment with CdE to see whether ON or OFF works.
Jim
> >I had a similar problem with an Icom 761. I cured it by reducing the
interface
> >speed to 4800 baud.
>
> I too have found that you can't run faster than 4800 in CT with my 756Pro.
>
> >By the way(1), you don't need to set the speed when invoking the COMTSR.
Just
> >set the speed in the CT comm setup screen.
> >
> >By the way(2), you should contact Joe Spear and get upgraded to Hyperlog
4.14 --
> >much, much, much improved over the years (I've been running Hyperlog
since
> >1988.)
>
> By the way(3), you should upgrade to CT 9.83, available on the website.
>
>
> _______________________________________________
> CT-User mailing list
> CT-User@contesting.com
> CT-User-request@contesting.com Subject=unsubscribe to unsubscribe
> http://lists.contesting.com/mailman/listinfo/ct-user
|