I have just installed ct v8.35 for the first time. I have had it since 1993
but haven't done anything with it. I have placed an order for an upgrade to v9
I have the CW key attacted to the DTR line 20 on serial port 2. When
installing 'comtsr2' the DTR line goes 'high' until I run 'ct' and key for
the first time.
All lines on port 2 DB25 are unmodified except for the additional
connection to DTR line #20 and ground line #7 for the CW keying circuit.
I can disconnect the DTR line quite easily but plan on using a SPST swith
and only swith it 'on' after I make a first CW key-stroke.
Is there some other way to make to DTR line 'low' when installing comtsr2 ?
Dave Drew W7DPW
Vancouver, WA
ddrew@pacifier.com
--
Submissions: ct-user@contesting.com
Administrative requests: ct-user-REQUEST@contesting.com
WWW: http://www.contesting.com/ct/
Questions: owner-ct-user@contesting.com
|