CT-User
[Top] [All Lists]

Re: [ct-user] CT DOS Comport Configuration Query

To: N6KI Dennis Vernacchia <n6ki_73@sbcglobal.net>,ct-user@contesting.com
Subject: Re: [ct-user] CT DOS Comport Configuration Query
From: Ed K1EP <k1ep.list@gmail.com>
Reply-to: k1ep.list@gmail.com
Date: Thu, 14 Jun 2007 21:49:26 -0400
List-post: <mailto:ct-user@contesting.com>
Did you type SETUP after that to let the program know which port the radio was 
on?

At 6/13/2007 05:05 AM, N6KI Dennis Vernacchia wrote:
>I have a Celeron machine running WIN98SE
>I am trying to get set up for a ham friend
>
>Problem is it only has 1 COM port on Mother Board
>
>I managed to find a NEW 2 COM Port ( 2 DB-9s connectors)
>PCI board which I installed and the floppy disk that came with it
>had drivers for DOS and also WIN98
>
>I did check the company's web site for any new drivers
>and the DOS and WIN98 drivers were the same as on the diskette
>
>Machine is set to boot into Straight DOS without
>loading any Windows Driver
>( set GUI=0 in System.ini file )
>
>That works fine, it boots into DOS on turn on
>
>I installed the card and DOS driver and I am able to
>do a port test with a DOS Utility and both COM ports
>checkout fine.
>
>In the CT Directory I load
>COMTSR1 ( For my Telnet Packet input and that works fine )
>
>I am trying to do radio control for a
>Kenwood TS-950 on one of the new ports on the
>Plug in serial card
>
>I typed
>
>COMTSRX -A2E8 -B4800
>( Where X = 2, 3 and 4 com ports.....to no avail)
>
>Any ideas what I am doing wrong
>
>The Blue confirmation Window always comes up and verifies that
>I did in fact get the  desired COM port and the port address
>
>( The Serial card booklet instructed me that port addresses
>are 2E8 and 3E8
>
>( N81 for other defaults as usual )
>
>I also went intoi WIN 98 and loaded those drivers just to be sure
>WIN98 sees the ports and all is wel there but I know not
>to run CT for DOS in WIN98
>
>I do NOT want to run CTWIN if I can help it as have
>had too many problems in the past with Video chipsets etc
>not working correct with CTWIN )
>
>Ant DOS gurus out there with some other solutions ?
>
>73, Dennis N6KI
>Sandy Eggo
>
>
>
>_______________________________________________
>CT-User mailing list
>CT-User@contesting.com
>http://lists.contesting.com/mailman/listinfo/ct-user
>CT on the web:  http://www.k1ea.com/

_______________________________________________
CT-User mailing list
CT-User@contesting.com
http://lists.contesting.com/mailman/listinfo/ct-user
CT on the web:  http://www.k1ea.com/

<Prev in Thread] Current Thread [Next in Thread>