So, what is standard and NON-standard POE support? Swapping of + and - on
4/5 & 7/8 ?
-bob
=========================
Jumper Setting for the WPBASE+, WPCPE+ and WPAP+
J302 Top slot Cardbus/PCMCIA power select
Pins 1 & 2 Jumpered - 3.3 Voltage Selected
Pins 2 & 3 Jumpered - 5.0 Voltage Selected
J303 Bottom slot Cardbus/PCMCIA power (WPBASE+ & WPAP+ Only)
Pins 1 & 2 Jumpered - 3.3 Voltage Selected
Pins 2 & 3 Jumpered - 5.0 Voltage Selected
J1 Enable PoE injector on Second Ethernet Port (eth2)
Both Pins 1 has 2 jumpers - Not Jumpered (default)
Jumper both sets of Jumpers (1 & 2) if the second Ethernet Port is to be
used as a Power over Ethernet injector, supplying power to another PoE
enabled attached device
J3 Future Support
J4 Non-Standard PoE Support
Pins 1 & 2 Not-Jumpered -Standard Poe Support Only
Pins 1 & 2 Jumpered - Non-Standard PoE Support
----- Original Message -----
From: "Kevin Knuth" <kknuth@karlnet.com>
To: "Karlnet Mailing List" <karlnet@WISPNotes.com>
Sent: Thursday, March 13, 2003 12:12 PM
Subject: RE: [Karlnet] New KN Board Documentation
>
http://www.karlnet.com/Product/SystemBoard/Jumper%20Setting%20for%20the%20WP
> BASE.htm
>
> Kevin
>
> -----Original Message-----
> From: karlnet-bounces@WISPNotes.com
> [mailto:karlnet-bounces@WISPNotes.com]On Behalf Of Nate McLain
> Sent: Thursday, March 13, 2003 12:43 PM
> To: Karlnet Mailing List
> Subject: [Karlnet] New KN Board Documentation
>
>
> Is there any documentation on these new boards?
> I got my hands on one of the new boards and there isn't any info with them
> at all. What are the jumper settings, etc....
>
> Nate
>
>
> _______________________________________________
> Karlnet mailing list
> Karlnet@WISPNotes.com
> http://lists.wispnotes.com/mailman/listinfo/karlnet
>
> _______________________________________________
> Karlnet mailing list
> Karlnet@WISPNotes.com
> http://lists.wispnotes.com/mailman/listinfo/karlnet
>
|