Nate
The average injector mold cost about $10k to $30k to make so they only
way to makes sent is if you do a very large run even $10k its still a $1
before the cost of the material and labor to make it and don't forget
margin on the product itself :) So its not as cheap as you would think.
Question why would you need to get to the CF, at least for now its not
used.
Also FYI our enclosures are setup for the new board:
http://www.demarctech.com/products/reliawave-ode/reliawave-rw-ode-8585-k
it.html
We can bundle a kit for the board for about $85-$75 so you only need to
add the board and card in qty of 10-15.
Sincerely, Tony Morella
Demarc Technology Group, A Wireless Solution Provider
Office: 908-996-7995 Cell: 908-246-9170 Fax: 908-847-0202
http://www.demarctech.com
> -----Original Message-----
> From: karlnet-bounces@WISPNotes.com
> [mailto:karlnet-bounces@WISPNotes.com] On Behalf Of Nate McLain
> Sent: Thursday, March 20, 2003 11:25 PM
> To: Karlnet Mailing List
> Subject: [Karlnet] Simple Plastic Backplates
>
>
> Are there any plans for KN to sell a simple plastic backplate
> for the new boards that are shipping? It would be nice to be
> able to have them made out of plastic and have the ability to
> isolate the board with the plastic backplate. Maybe using the
> same type of setup that was on the RG cases. That would allow
> for access to the compact flash socket when you need to get
> to it. I would think that these could be produced by a
> injector molding shop in mass quantities at a very cheap price.
>
> Are there any plans for something like this??
>
>
> Nate
>
>
> _______________________________________________
> Karlnet mailing list
> Karlnet@WISPNotes.com
> http://lists.wispnotes.com/mailman/listinfo/ka> rlnet
>
>
|