Before I flash the AP it has the default Orinoco IP. 153.x.x.x
I connect via a croosover cable, flash the AP, then it resets itself.
Then I never get a ethernet connection to it. When I connect via a wireless
card in my laptop it has the Karlnet IP of 198.17.74.254. So I gave myself a
198.17.74.100 IP in the same subnet and still no go with the ethernet
cable... This is really weird...
I can always put it back into base boot mode. And it has the 153 IP again.
Nate
-----Original Message-----
From: karlnet-admin@WISPNotes.com [mailto:karlnet-admin@WISPNotes.com]On
Behalf Of Roger Boggs
Sent: Tuesday, October 01, 2002 1:52 PM
To: karlnet@WISPNotes.com
Subject: Re: [Karlnet] AP-1000 Goofyness
Yes, but is the default IP address of the KarlNet Bridge firmware the same
as
the default IP address of the Orinoco AP1000 AP?
Assume NOTHING. If the default addresses are different before and after
firmware flash, then it would make sense that you would have to reconfigure
your configuration computer to the new address/subnet before you could
continue.
But then again, maybe not.....
At 01:34 PM 10/1/02 -0500, you wrote:
>I have a AP-1000 that doesn't work right.
>I can see it via a scan of the configev program.
>Once I flashed the radio with the proper bin file and license the ethernet
>port NEVER comes back up... You never get a connect to it with a crossover
>cable.
>But I can access it via a wireless connection. The ethernet port is enabled
>but still no go. I have verified that the crossover cable it good..
>
>Has anyone else seen this problem??
>I can't figure out why the ethernet port is just dead.
>
>Nate
Roger Boggs
_______________________________________________
Karlnet mailing list
Karlnet@WISPNotes.com
http://lists.wispnotes.com/mailman/listinfo/karlnet
|