> I have a new laptop at work and as usual I had a share of WIN98 installed
> in the event that I wanted to run NA during a test. Unfortunately, the
> laptop (Compaq NC6000) is so new that WIN98 is not supported.
>
> My problem is that I can't get NA (v10.59) to key my TS830. The laptop
> sound card generates the CW, but doesn't key the rig. I have the same
> configuration (IRQ, etc.) in this version of NA as I had for version 10 so
> I think that issue is cleared.
>
> I'm looking for help to set the right parameters within WIN98 to make the
> keyer work.
>
> Any help getting me back on the air would be greatly appreciated.
>
> Thanks & 73,
>
> Roger ...
> KA9EKJ
>
>
> ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
> Roger Hoeft
> Senior Systems Consultant
> <<...OLE_Obj...>>
> (256) 730-1662 (256) 730-1350 (fax)
> Roger.Hoeft@intergraph.com
> http://www.intergraph.com <http://www.intergraph.com>
> ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
>
>
_______________________________________________
NA-User mailing list
NA-User@contesting.com
http://lists.contesting.com/mailman/listinfo/na-user
NA on the web: http://www.datomonline.com/
|