[NA-User] System Requirements

["Dennis Ponsness" <wb0wao@hotmail.com>]

Dave and group,

  I am presently in the stage of "upgrading" my station for the ultimate 
goal of a 2 rig multi op setup and have a question...

For reference, I am using a P4 with Win XP Home (both machines) and want to 
run them in a network configuration and also use rig control and WinTelnetX 
for spotting.

1) Lack of COM Ports - I believe that I can overcome this by installing an 
I/O board with 2 additional COM ports on them.  I think I am limited to 4 
COM ports total (correct me if I am wrong), so with that in mind, would the 
following "work"...

Computer #1 - Station #1 (online to Telnet)

COM 1  Rig Control (K2)
COM 2  WinTelnetX out
COM 3  NA Network (to Computer #2)

Computer #2 - Station #2 (not online)
COM 1  Rig Control (K2)
COM 2  WinTelnetX in
COM 3  NA Network (from Computer #1)

The only thing that I am not sure about is the WinTelnetX configuration.  I 
know that it needs 2 COM ports to work "correctly" - I want to be able to 
send spots as well as RX them!  Does it matter if the COM ports are on 
different machines?  And I would assume that the spots coming into Station 
#2 would be sent over the NA Network to show up on Station #1.

TNX es CU in the 'tests!

73

Dennis - WB0WAO

EN84ij Iosco County, Michigan
K2 #3555

Charter Member - Michigan DX Association
www.qsl.net/wb0wao
:=)

_________________________________________________________________
Never get a busy signal because you are always connected  with high-speed 
Internet access. Click here to comparison-shop providers.  
https://broadband.msn.com

_______________________________________________
NA-User mailing list
NA-User@contesting.com
http://lists.contesting.com/mailman/listinfo/na-user
NA on the web:  http://www.datomonline.com/