In einer eMail vom 21.09.2004 21:36:57 Westeuropäische Normalzeit schreibt
ua3ap@smtp.ru:
Dear Orion users:
I'm looking for Orion users who run it with ACOM 2000. I've
got the following issue while transmitting CW. Within some
time after I start TX in CW mode, ACOM-2000 alarming "ARC
fault". If I use ACOM-2000 with another rig (Ft-1000MP)
problem goes away.
I would very appreciate if users with the same set up will
share with me their experience.
Thanks in advance
73, Sergei - UA3AP
Moscow
Hi Sergei!
I use the Orion with the Acom 1000. ARC fault is shown, while "hot
switching" the TX / RX relay of the amp. U can use a longer CW QSK Delay or Ext
T/R
Delay in the menu CW or TX of the Orion. This should help.
Vy 73, Randolf,DL6KAI
_______________________________________________
Orion mailing list
Orion@contesting.com
http://lists.contesting.com/mailman/listinfo/orion
|