I have lost TX (and RX) audio in the past, but it was always corrected
by a master reset.
73, Joe
K2XX
Sherman Banks wrote:
> I have 2.059d in an Orion I and I just ran into an interesting problem.
> While trying to work N8S split on 40M SSB, I did not have any TX audio.
> But if I don't work split, I had audio.
>
> After some experimentation, the radio seems to not like transmitting in
> the US portion of the 40M phone band when split. I can swap the VFOs so
> that I TX low and I get audio. But that's not good. I can swap the VFOs
> back to what they should be and my audio will be there for one
> transmission and then go away.
>
> I then tried to swap the VFO A and VFO B buttons on TX/RX and Sub RX.
> When I tried to set them to TX on the right frequency there is no audio.
> If I swap them to the wrong VFO, then it works.
>
> No TX Audio
> VFO A 7.212 TX Sub RX
> VFO B 7.080 RX
>
> TX Audio
> VFO A 7.212 TX RX Sub RX
>
> TX Audio
> VFO A 7.212 RX
> VFO B 7.080 TX, Sub RX
>
> No TX Audio
> VFO A 7.080 RX
> VFO B 7.212 TX, Sub RX
>
> TX Audio
> VFO A 7.080 TX, Sub RX
> VFO B 7.212 RX
>
> It doesn't matter which VFO is on the Sub RX.
>
> Is this a known issue with 2.059d and is there a work around?
>
>
> _______________________________________________
> Orion mailing list
> Orion@contesting.com
> http://lists.contesting.com/mailman/listinfo/orion
>
>
>
_______________________________________________
Orion mailing list
Orion@contesting.com
http://lists.contesting.com/mailman/listinfo/orion
|