Re: [Orion] firmware Questions

[Gary Tuck <gtuck@mac.com>]

I've commented on the AGC popping situation here and have found few 
others who seem to be experiencing the problem.  I know that if I use 
higher impedance headphones, 64 ohm, it really helps--over my HS-5's  
even if I put 47-100 ohm resisters in the  audio lines with the 8 ohm 
cans.

My Sweep does not freeze if I make sure that NR is off in the Sub 
receiver.

There are two mic gain adjustments.  One is under the transceiver thru 
a small hole a couple inches back from the front behind the User 
buttons.  I placed my front panel mic gain at 50 and then adjusted the 
circuit board pot with a small insulated driver and that helped. Any 
further adjustment was with the front panel control. Paul in Service 
told me about this.

When you say transceiver freezing, what are you experiencing?  I know 
that before I upgraded to 1.372 I had a couple of receiver freezes 
(either main or sub) and then a couple of times after the upgrade.  I 
didn't like the audio popping and delays I experienced with BW, Cut and 
AF so I reinstalled 1.371 after clearing ram and doing a master reset.  
Then another master reset after the 1.371 install.  I felt like I was 
re-formating the drive and re-installing a clean operating system on a 
fairly new PC.  The receiver freezes have not come back.  I was getting 
transmitter freezes--keying but no power output--after using my 
Centaur.  Tommy had understood another ham had turned both Keying Loops 
on and that had helped.  I've been trying that and have not experienced 
another problem.  Doesn't seem logical and may not be related but it's 
working so far for me.

I got my Orion September 1st so ours are probably from the same 
production run.

73,  Gary W7TEA


On Jan 5, 2005, at 10:54 AM, skip wrote:

> I've been reading the mail for a while and also I have made some 
> comments
> about the Orion's Firmware problems.  I got my Orion in September or 
> 2004.
>
> The AGC seems to have problems with popping as I think the Agc is 
> released.
> Sweep display and transceiver freezing and needs reset
> I use a Heil Proline mic and cable I purchased from TT and it seems 
> that the
> mic gain has to be set at almost 100%
> Key Clicks @ 20- 30 wpm
> some other problem but not as bad as the above.
>
> Do all Orion's have this ????  I see guy's on the Ten Tec reflector 
> saying
> they never had any problem with their radio.  How can this be if it's 
> in the
> firmware ?????????
>
> de Skip     K3CC
>
> _______________________________________________
> Orion mailing list
> Orion@contesting.com
> http://lists.contesting.com/mailman/listinfo/orion

_______________________________________________
Orion mailing list
Orion@contesting.com
http://lists.contesting.com/mailman/listinfo/orion