RFI
[Top] [All Lists]

Re: [RFI] Common Mode Line Filter

To: rfi@contesting.com
Subject: Re: [RFI] Common Mode Line Filter
From: David Cole <dave@nk7z.net>
Reply-to: dave@nk7z.net
Date: Mon, 11 Aug 2014 06:39:11 -0700
List-post: <rfi@contesting.com">mailto:rfi@contesting.com>
Hi Jim,
Thanks for the expansion on that...  I know less than I want to know
about Power Line...  Any way you know of, that a power company will go
along with, to clean up power as it arrives?  Ferrite's on the power
lines etc?  I am almost afraid to ask the power company about adding
ferrite's to the incoming lines.
-- 
Thanks and 73's,
For equipment, and software setups and reviews see:
www.nk7z.net
for MixW support see;
http://groups.yahoo.com/neo/groups/mixw/info
for Dopplergram information see:
http://groups.yahoo.com/neo/groups/dopplergram/info
for MM-SSTV see:
http://groups.yahoo.com/neo/groups/MM-SSTV/info


On Sun, 2014-08-10 at 22:15 -0700, Jim Brown wrote:
> On 8/10/2014 10:03 PM, David Cole wrote:
> > Which forces me to ask...  What does the power company call common mode?
> 
> The voltage between neutral and green.
> 
> Thanks to a "Pin One-Like Problem" in most equipment, common mode often 
> trash leaves equipment on the green wire, which radiates it. The Green 
> wire SHOULD be bonded to the chassis at the point of entry, but it often 
> is not. Instead, it goes to the circuit board, and may eventually find 
> the chassis. Sometimes it fails to hit the chassis because paint is in 
> the way. This is "The Pin One Problem."
> 
> In virtually all commercial line filters, the green wire bypasses the 
> filter, so the filter does nothing to kill common mode current.
> 
> 73, Jim K9YC
> _______________________________________________
> RFI mailing list
> RFI@contesting.com
> http://lists.contesting.com/mailman/listinfo/rfi

_______________________________________________
RFI mailing list
RFI@contesting.com
http://lists.contesting.com/mailman/listinfo/rfi

<Prev in Thread] Current Thread [Next in Thread>