RFI
[Top] [All Lists]

Re: [RFI] w7ekb & ground rods

To: rfi@contesting.com
Subject: Re: [RFI] w7ekb & ground rods
From: "Roger (K8RI)" <k8ri@rogerhalstead.com>
Date: Fri, 16 Jan 2015 10:53:41 -0500
List-post: <rfi@contesting.com">mailto:rfi@contesting.com>
Although multiple ground rods need to be bonded together, the typical system has the tower ground and station SPG on opposite sides of the house. Even though bonded the transient rise time can produce substantial voltages between the coax shields and the power into the equipment.

73

Roger  (K8RI)



On 1/15/2015 5:45 PM, D C _Mac_ Macdonald wrote:


DX Engineering carries flat copper tape.  I bought 25' to use divided into thirds to 
taper connect each tower leg to a ground rod outside the concrete foundation.  They 
also have special clamps for the tower legs AND 5/8" ground rods that will 
resist corrosion.
Copper braid from coax will disintegrate from a lightning hit. All those copper strands add up to a whole lot of inductance and therefore, inductive reactance and a huge voltage drop. I have seen the little bit left of braid shield after a tower has taken a strike! * * * * * * * * * * *
* 73 - Mac, K2GKK/5 *
* (Since 30 Nov 53) *
* k2gkk hotmail com *
* Oklahoma City, OK *
* USAF & FAA (Ret.) *
* * * * * * * * * * *
From: kgordon2006@frontier.com
To: jim@audiosystemsgroup.com; Rfi@contesting.com
Date: Thu, 15 Jan 2015 13:40:26 -0800
Subject: Re: [RFI] w7ekb & ground rods

Jim:

After reviewing the above link (and downloading it), it seems quite obvious
that I have one hell of a lot of work to do.

Can you suggest a source for flat wide copper "tape" ?

And for copper braid, other than from old coax? (I suspect braid from old
coax will not be wide enough, and if it is corroded, the individualy strands of
copper may be insulated from one another.)

So....it appears that my moving that useless 30+ feet of #8 "ground" wire DID
reduce my local noise level by a good 10 dB.

I would never have thought of that in a million years.

Ken W7EKB
                                        
_______________________________________________
RFI mailing list
RFI@contesting.com
http://lists.contesting.com/mailman/listinfo/rfi



---
This email has been checked for viruses by Avast antivirus software.
http://www.avast.com


_______________________________________________
RFI mailing list
RFI@contesting.com
http://lists.contesting.com/mailman/listinfo/rfi

<Prev in Thread] Current Thread [Next in Thread>