The lighting industry folks call the power supplies "Drivers", usually
constant current type.
Steve
sparkie001@pobox.com
stevew7sjk@gmail.com
www.facebook.com/imetsteve
On Thu, Jun 14, 2018 at 11:40 AM, Dennis Monticelli <
dennis.monticelli@gmail.com> wrote:
> My former employer designed and produced the chips that control LED lights.
>
> Yes, there is a "ballast" in each one but a better description is switched
> mode power supply. Like any SMPS there is the potential issue of excessive
> conducted mains emission that turns into radiated emission via the power
> line (green wire included) acting as an antenna. CM chokes are the answer.
>
> Unfortunately there is potentially another more insidious source of noise.
> Yup, direct radiation. The SMPS is of the current output type, not the
> voltage output type. Because your eye cannot visualize the optical ripple
> that derives from current ripple (the eye sees only the average), it is
> common for the circuit designer to cut costs by lightly filtering (or not
> filtering at all!) the current ripple. The LED's are series strung
> so.....you guessed it....there is a large current loop involved. If the
> return path is not properly managed for field cancellation, you've got
> yourself a healthy direct radiator.
>
> This situation cannot be easily corrected. Trying to add current filtering
> is likely to mess up the feedback loop. Basically, it's a redesign. If
> one goes to the trouble of a redesign then I encouraged ripping out the
> SMPS board and using a linear wall adapter along with a series resistor to
> set the current. Yeah, the efficiency would drop but the result would be
> absolutely zero noise of any kind because the LED's themselves are dead
> quiet.
>
> Dennis AE6C
> _______________________________________________
> RFI mailing list
> RFI@contesting.com
> http://lists.contesting.com/mailman/listinfo/rfi
>
_______________________________________________
RFI mailing list
RFI@contesting.com
http://lists.contesting.com/mailman/listinfo/rfi
|