Hi Neal,
I use the microHAM micriKEYER and it works very well with everything
I've tried. I've configured it to run the following:
Software:
MMTTY - RTTY FSK and RTTY AFSK
DXLab WinWarbler - RTTY FSK, PSK, CW QSK
N1MM Logger - RTTY FSK, PSK, CW QSK
WriteLog - RTTY FSK, PSK, CW QSK, CW PTT
DXBase - CW PTT (haven't tried PSK)
Here is my setup
microKEYER ports:
Radio control: Com5
FSK: Com6
CW: Com3
PTT: Com7
I'll give you my settings for MMTTY. Once you get that going you can
get just about anything else working.
MMTTY settings in Option (O) under "Setup MMTTY (O)..":
Under TX Tab: PTT = Com 6
Radio command button:
Port = Com7
DTR/RTS PTT is checked
You'll have to fill in the port definition yourself for your rig for
baud, data length stop and parity.
Misc Tab:
TX Port pick Com-Txd(FSK)
USB Port Button pick C: Limiting speed
Device ID: This should be -1 if you only have one sound card and it has
the default address. You might have to use trial and error if you don't
get a receive signal through MMTTY. Try -1, 0, 1, 2, or 3. For example
my computers MB sound card is -1 but I use a separate Turtle Beach Santa
Cruz card for ham radio and it is 3.
If you have any trouble I recommend you contact Jozef at microHAM
support. He is very, very helpful, tough he is on a different sleep
cycle that we are so it may take him a day to respond.
Good luck and 73,
Art
W2NRA
Neal Campbell wrote:
> Hi guys!
>
> Has anyone had any luck using RITTY with a USB-serial port? I have a
> wonderful microham microkeyer and have run out of ideas on how to make it
> send FSK/PTT through one of those virtual comm ports. Would really like to
> see it work!
>
> 73 de Neal k3nc
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
|