My Rigblaster Pro is plugged into an add-on com port board from a
previous computer. Windows 10 id'ed the board and my com port is 2.
No driver was needed. No problems.
Alan
WD9GMK
On 5/24/2016 7:55 PM, Al Kozakiewicz wrote:
The Rigblasters themselves are just interfaces, no driver is needed.
I'm pretty sure the CD that comes with the product just has a collection of
digital ham shareware, the documentation and the drivers for the included
USB-Serial cable if that is required. If there is a problem that's likely to be
the source. I have no idea if they use the Prolific or FTDI chipset. The
Prolific is a headache if you don't find the right driver - most of the ones
freely available are crap. But in either case I'd bet dollars for donuts that
the USB driver supplied doesn't support Windows 10.
If all else fails you can always just purchase another USB-Serial cable with a
driver that works under Windows 10.
Al
AB2ZY
-----Original Message-----
From: RTTY [mailto:rtty-bounces@contesting.com] On Behalf Of Don Hill AA5AU
Sent: Tuesday, May 24, 2016 4:35 PM
To: rtty@contesting.com
Subject: [RTTY] Rigblaster Plus & Windows 10
Had someone who owns a Rigblaster Plus contact me to say they are having
trouble getting Windows 10 to recognize the Rigblaster.
Anyone using this combination and let me know what driver they used.
Thanks,
Don AA5AU
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
|