I don’t see the 5 minute band change limit in the BARTG 75 rules. Is this an
oversight or is there no restriction on band changes for 75 baud?
tnx,
Ken K6MR
From: Bill Turner
Sent: Saturday, 20 September, 2014 18:22
To: rtty@contesting.com
A reminder of the BARTG 75 Sprint Contest which starts tomorrow,
Sunday UTC at 1700. This is a four hour contest using 75 baud RTTY.
Rules at: http://www.bartg.org.uk/sprint75contest.asp
Note: do not send RST.
Follow these steps to change MMTTY to 75 baud:
I use FSK only, but I assume this applies to AFSK as well. If not,
please let me know.
1. Start MMTTY and go to Options>Setup MMTTY and select the
Demodulator tab.
2. At the bottom, UN-check the box that says "Fixes 45.45 baud".
3 Go to the Decode tab and change the baud rate to 75.
4. Click OK. Do not skip this step or changes will not be saved.
Don't forget to change 2Tone if you are using it. You'll figure it
out. :-)
This contest is a lot of fun, very different feel from the usual. Hope
to see you there.
73, Bill W6WRT
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
|