----- Original Message -----
From: "Carol Richards" <n2mm@comcast.net>
> 3. I cannot get the rig to key using any of the
> memories...What did I forget to do?
Use the STATUS command to confirm that Sidetone is
OFF - SD does not offer simultaneous keying and
sidetone. If necessary, use the SIDETONE command
to toggle the setting.
> 4. With the sidetone on, I can hear the messages fine, but
> the escape key doesn't interrupt the message
That's normal - Esc will work with regular keying.
> 5. Is there an auto repeat command?
Yes, R (followed by Enter) toggles auto-repeat for
your F1 (CQ) message.
Then R1 to R10 adjusts the delay between repeats.
Try R5 initially, then reduce it as appropriate.
> 6. What does ESM do and what is the best setting?
ESM (Enter Sends message) allows you to have CW
QSOs in Run or S&P modes - using the Enter key
only.
With ESM on (toggled with ' apostrophe), and in
Run mode, Enter from an empty Callsign field sends
your F1 message. Enter, from a completed Callsign
field sens the callsign and full exchange (your
F2 message). Enter, from the Zone field, sends
your F3 Message - TU N2MM - and you're ready for
the next caller.
In S&P mode, the messages change as appropriate.
You toggle between Run and S&P mode using the
key directly under the Esc key.
73,
Paul EI5DI
_______________________________________________
SD-User mailing list
SD-User@contesting.com
http://lists.contesting.com/mailman/listinfo/sd-user
|