On 23 Jun 2005 at 16:49, Dave Sergeant wrote:
> OK I have just downloaded and installed v11.32 on my Windows 98SE
> laptop. Runs OK, BUT..
>
> The full date and time are not always displayed in the date/time
> window - the box is foreshortened and it only displays the date and a
> dash, with the time missing. While playing about I did get it display
> properly once, but couldn't repeat it. The time (less seconds) is
> correctly displayed in the logging window against each QSO.
Update on this one.
It seems to only happen if I have the rig control port enabled (on
serial port 1, a genuine serial port, Kenwood interface driving my
K2). As soon as I enable this port the time field stops clocking, and
also the time shown against the current QSO stops - but logs the
correct time as soon as I log the QSO. CW port is disabled.
If I disable the rig port and re-start SD all is fine.
If I then quit SD and rerun it, opening that log or any other, I get
the foreshortened time field I mentioned.
SD Dos 10.15 runs fine, as did 11.06 I used last week.
Obviously the joys of Windows programming...
73 Dave G3YMC
http://www.davesergeant.com
_______________________________________________
SD-User mailing list
SD-User@contesting.com
http://lists.contesting.com/mailman/listinfo/sd-user
|