Hello all;
In previous edition of SD I noticed strange behaviour of the cursor
jumping right away from call to RTS area; that was probably fixed in
current version.
In current version I can see also something, than is probably not guite
right:
Communication radio<>computer is working - for example when I type C
in call area to change mode to CW - all is ok - radio follows computer
and goes to CW. Also when I type S in call area <enter> - radio goes
back to SSB and all looks OK on my computer screen.
The story is diffrent when I switch mode on my rig: - SD follows my rig
and goes to radio's mode..BUT>>> for some reason the FREQUENCY DISPLAY
(yellow digits bellow the call area) gone.. If I want to see that
frequency display again - I must change vfo just abit - then SD will
show QRG again.
Im not sure - if this is just bahaviour of my computer, or the problem
is in the guts of SD.
This is not a total tragedy, but will be nice to see it working as expected.
Perhaps there is somebody out there with perscription...how to cure
it..thank's in advance!!
73, de Andrew VK2AR
_______________________________________________
SD-User mailing list
SD-User@contesting.com
http://lists.contesting.com/mailman/listinfo/sd-user
|