If memory serves me the PROII (out of the box) is dec 100 hex 64.
5c/92 is for the PRO
73 Don
----- Original Message -----
From: "Tod - MN" <tao@skypoint.com>
To: <trlog@contesting.com>
Sent: Monday, December 29, 2003 02:54
Subject: [Trlog] "tell me where to go ..."
I need someone to point me in the right direction to resolve a problem I am
having controlling an ICOM756Pro-II using TRLog.
I have a JBI products interface module which is used to connect to the ICOM
radio. I am able to control the radio (read and set the frequency and
provide CW keying) when I use DX4WIN as the control program.
When I try to use TR 6.71 to control the radio I am able to have TR doing
the keying but TR does not control the radio band/mode settings and does not
seem to read or set the frequency.
The settings for the COM port in DX4WIN are COM1, CW key with DTR, Baud rate
= 4800, radio address= 5C(hex)
The TR settings are the same except the radio address is 92.
I have tried to use TR-Log under Windows98 and also DOS 6.22 . Neither
provides computer control of the radio nor frequency reading of the radio.
I suspect this has been covered in some previous communication to the
reflector. I am looking for suggestions on what to search the archives for
to get to the earlier messages.
Thanks in advance for any help --- direct or indirect.
Tod, KØTO
_______________________________________________
Trlog mailing list
Trlog@contesting.com
http://lists.contesting.com/mailman/listinfo/trlog
_______________________________________________
Trlog mailing list
Trlog@contesting.com
http://lists.contesting.com/mailman/listinfo/trlog
|