Re: [Trlog] Keyboard command to switch vfos

[Ronald Rossi <kk1l@intergate.com>]

You need a semi-colon at the end of each command for the Kenwoods. It is 
likely the same for Elecraft.

FR0; = VFO A Rx
FR1; = VFO B Rx
FT0; = VFO A Tx
FT1; = VFO B Tx

Ken Beals wrote:

> Bob:
>
> Go to the Elecraft site and download the "KIO2
> Programmer's Manual".  It has all the codes for the
> K2.  
>
> Looks like an FR0 (that's a zero) will set VFO A
> receive, FR1 sets VFO B receive.  This command also
> sets the split mode on/off automatically.  That should
> be all you need.  
>
> Otherwise you can always use the SW commands and get
> any combination of button presses you need.
>
> Ken
>
> --- Bob Tellefsen <n6wg@comcast.net> wrote:
>
>
> > I'm working on programming a couple of buttons to
> > allow
> > keyboard switching from vfo A to B and back again.
> > George Fremin pointed me to section 5.3 in the
> > manual, which
> > shows how, sort of, but I need to know what codes a
> > Kenwood
> > would want to see to do this.  I'm actually using a
> > K2, but it is
> > supposed to accept the Kenwood codes.
> >
> > Can anyone help with this?
> > Thanks and 73
> > Bob N6WG
> > _______________________________________________
> > Trlog mailing list
> > Trlog@contesting.com
> > http://lists.contesting.com/mailman/listinfo/trlog
>
>
> _______________________________________________
> Trlog mailing list
> Trlog@contesting.com
> http://lists.contesting.com/mailman/listinfo/trlog

--
73 es God Bless de KK1L...ron (kk1l@arrl.net) <><
QTH: Jericho, Vermont
My page: http://www.qsl.net/kk1l
_______________________________________________
Trlog mailing list
Trlog@contesting.com
http://lists.contesting.com/mailman/listinfo/trlog