Hello,
I have observed an interesting problem regarding the rig interface with
my FT-100. Ver 6.70 zip file - but display indicates ver 6.69.
1) Using a 286-based Toshiba 2200SX Laptop with Parallel CW interface and
serial rig control - works fine
2) Using Toshiba 2650(?) Satellite Windows 98 (not SE) running TR from a DOS
window and operating CW - the program apparently wants to switch the
radio back into SSB mode but then decides that indeed CW is the correct mode.
So in the end, after I log a QSO the program switches to SSB, then back to CW
- sometimes doing this several times over a period of 5 or more seconds before
settling on "CW" for good. This is fine except when entering another call into
the window when all of this is going on - which then causes the program to
crash -
sometimes.
When I boot into MS-DOS mode with (2) - TR comes up but there's no
functionality.
Any ideas?
Thanks in advance,
73,
Dave, K0DI
|