I have the same result using Ham Radio Deluxe Version 4.0 SP4 build 1901.
Gary
VE7AQ
-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
On Behalf Of Rick W
Sent: May 14, 2009 10:28 PM
To: Ten-Tec Reflector
Subject: [TenTec] Orion 565 Problem with 2.063Xg??
I think I've found a problem with 2.063Xg. Here's the scenario.
1) I have my 565 under the control of the N4PY software.
2) I go to the RX menu and toggle the AGC System Type (it doesn't seem
to matter which way I go).
3) Back out of the menus
After doing this exercise I lose all serial control of the Orion. In
addition the remote pod doesn't work. The work-around is to turn off the
software and reboot the Orion.
IF I am not using the serial port with an external program and toggle the
AGC the remote pod works BUT when I try to start some external software the
serial port is dead. The same work-around solves the problem.
Before I report this to T-T I'd be curious if others are experiencing this?
Thanks.
73,
Rick
VE7TK
Website: http://www3.telus.net/ve7tk
__________________________________________________________________
The new Internet Explorer® 8 - Faster, safer, easier. Optimized for Yahoo!
Get it Now for Free! at http://downloads.yahoo.com/ca/internetexplorer/
_______________________________________________
TenTec mailing list
TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|