I've found that the butane irons sold by Radio Shack work very well in
soldering PL259's, and they are small and portable
Dave WN5V
-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
On Behalf Of David Goncalves
Sent: Monday, April 05, 2010 4:54 PM
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] help in soldering pl259 outside
http://www.projectautox.com/large_soldering_irons.jpg
On Mon, Apr 5, 2010 at 5:52 PM, John Molenda <cdistflatfoot@gmail.com>wrote:
> Well it's that time again that is Antenna time . I was out side
yesterday
> in 60 degree temp and had a very diffucult time soldering on some
> connectors . Does anyone on the reflector have any tricks for soldering
> outside both my irons were not hot enough . Does anyone make a special
> slodering tool for such a job ? thanks John kb2huk
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
--
David Goncalves
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|
