Good 'ole Carl !! :)
Gary
AA2IZ
----- Original Message -----
From: "Jim Reid" <jimr.reid@verizon.net>
To: <tentec@contesting.com>
Sent: Thursday, February 05, 2004 7:14 PM
Subject: Re: [TenTec] Topband: BDR redux
>
> > If AGC Threshold control was reasonably accessible,
> > I bet you'd be using it all the time.
>
> Yes, sure enough! The Threshold may be set via a
> slider at the left side of the "virtual" Orion control
> panel when using the N4PY control software. Very
> nice that way. This continuous control is there all
> the time, no matter which AGC selection has been
> made. There is also a slider for RF gain on that
> virtual panel. I find each to be useful. BTW, the
> AGC threshold is printed in uV just below the slider
> on Carl's panel, so you always know where it is.
>
> 73, Jim KH7M
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|