Alan:
Thanks for the info. I needed to update the operating version from 1.019 to
1.021. Also did a update on the Boot Loader from 1.003 to 1.004 which is
REQUIRED. Updates were very easy and very fast and successful!
Thanks
73
Bob, K4TAX
----- Original Message -----
From: "Alan Sewell" <alan.n5na@gmail.com>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Sunday, October 14, 2007 6:26 PM
Subject: Re: [TenTec] Omni VII Temperature Control
> Yes, there is. Check the firmware history.
>
> Version 1.012
> Add Internal Temperature Control of approximately 70deg C
>
> Version 1.014
> Increase Over Temp Shutoff Temperature
>
> When 1.012 came out there were complaints of it shutting down when
> operating normally so the shutoff temp was increased in version 1.014.
> Maybe it needs to be bumped up a little more!
>
> This was apparently added to meet some European requirements.
>
> 73,
>
> Alan N5NA
>
> http://www.tentecwiki.org
>
>
>
> Bob McGraw - K4TAX wrote:
>> Is there a high temperature TX shutdown in the radio?
>>
>> 73
>> Bob, K4TAX
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
>>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|