TenTec
[Top] [All Lists]

Re: [TenTec] ten tec omni 546 c

To: <tentec@contesting.com>
Subject: Re: [TenTec] ten tec omni 546 c
From: "Mike Hyder -N4NT-" <mike_n4nt@charter.net>
Reply-to: tentec@contesting.com
Date: Wed, 30 Jun 2004 22:19:23 -0400
List-post: <mailto:tentec@contesting.com>
On back panel is antenna switch.  Go to and fro with that switch to clean
contacts.  Good Luck!

73, Mike N4NT

----- Original Message ----- 
From: "charles timothy" <two2first@yahoo.com>
To: <tentec@contesting.com>
Sent: Sunday, June 27, 2004 4:27 PM
Subject: [TenTec] ten tec omni 546 c


> Hello I am have trouble with my ten tec omni 546 C.I am rx more noise than
signal on all bands ;I presently  work 10-20 meters . (2)A very loud tone on
18.000.0   which pins the s meter full to the right;I rec no signal  as if
the band  is dead.(3)Sensitivity is very poor unless there is a strong
signal on the frequency.
> Tnx in advance for your reply
> Sincerely   Charles (8P6ET)

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>