My Brand New Argo V did the same thing within a month. TT promptly fixed
it. No problems since.
----- Original Message -----
From: "Bob Towers" <mm0rkt@beeb.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Monday, July 30, 2007 11:26 AM
Subject: [TenTec] Low power output on Argonaut V
> Some time ago the power output on my Argonaut V dropped to nearly zero
> on all bands.
>
> TenTec say the most likely cause is
>
> a) one or more of the switching diodes in the LPF circuits
> or
> b) blown finals
>
> I rarely ran it at more than 10W and was always pretty careful about
> running it into high SWRs.
>
> The rig is well out of warranty and getting it to TenTec across The Pond
> and back is pretty expensive, so I'm wondering whether to find and fix
> the problem myself.
>
> I've recently built a K2, so I'm not too scared of complex PCBs.
>
> Has anyone fixed a similar problem themselves? If so, any help would be
> much appreciated.
>
> 73
>
> Bob Towers
> MM0RKT
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|