Dave,
Thanks for the reply. That's part of the answer I need.
I know very little about AM operation. and that's the reason for the other
part of this question: Assuming that you did reduce the mic gain to avoid
over-modulation, would a speech processor'ed signal be more readable under
some conditions?
If so, I see another solution to your problem. The software could save and
use different gain settings for with processor and without.
73,
Mark
----- Original Message -----
From: "David McClafferty" <ve1adh@yahoo.ca>
To: "Mark Erbaugh" <mark@microenh.com>; "Tentec (E-mail)"
<tentec@contesting.com>
Sent: Wednesday, August 14, 2002 9:45 AM
Subject: Re: [TenTec] Pegasus Speech Processor
> The processor is active in AM but you must reduce the
> mic gain to avoid overmodulating so it is of no use.
> In N4PY's software the processor is turned off when
> you switch to AM or FM modes. I asked Carl to do this
> because I was forgetting to turn it off (reduce mic
> gain) and getting complaints of overmodulation in AM.
> With the processor off the mic gain can be left at the
> same setting for AM or SSB.
>
> 73, Dave, VE1ADH
>
> --- Mark Erbaugh <mark@microenh.com> wrote:
> > Does anyone know if the Speech Processor is active
> > or useful in AM or FM modes on the Pegasus? The
> > Speech Processor was added after my version of the
> > manual was printed, so it is not mentioned at all.
> > It's also not mentioned in the Programmer's
> > Reference Guide.
> >
> > 73,
> > Mark
> >
> >
> > --- StripMime Report -- processed MIME parts ---
> > multipart/alternative
> > text/plain (text body -- kept)
> > text/html
> > ---
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
>
>
> ______________________________________________________________________
> Post your ad for free now! http://personals.yahoo.ca
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
|