TenTec
[Top] [All Lists]

[TenTec] Amp with an Argosy

To: <tentec@contesting.com>
Subject: [TenTec] Amp with an Argosy
From: N4NT@wireco.net (Michael O. Hyder)
Date: Tue, 10 Aug 1999 04:36:37 -0400
The Argosy had an optional model 1126 Amplifier Switch board.  If you can
hear a relay in the Argosy, then you have the board installed.  It grounds
the center pin of the middle of the lower three phono jacks on the rear
panel.

Hope you have it installed already.

73 de Mike N4NT@wireco.net
  ----- Original Message -----
  From: Jim Esser
  To: tentec@contesting.com
  Sent: Tuesday, August 10, 1999 12:07 AM
  Subject: [TenTec] Amp with an Argosy


  I'm interested in using my Bandit 2000C linear amp with my Argosy II.  The
amp requires a relay closure.  Anyone have any ideas on getting the closure,
either from the Argosy or from outside of the Argosy?

  Jim Esser, WD9FRF


--
FAQ on WWW:               http://www.contesting.com/tentecfaq.htm
Submissions:              tentec@contesting.com
Administrative requests:  tentec-REQUEST@contesting.com
Problems:                 owner-tentec@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm


<Prev in Thread] Current Thread [Next in Thread>