Yes, thanks Mike. I had found R-16 after your first message, of course I
violated rule #1, RTFM. Never imagined an adjustment for that, figured a
component failure. Adjusted per the manual, also adjusted R-9 on the OT-TR
board, and the display timebase, used some wire wedges to tighten up the 10M
band crystal.
A long way from mint, but seems to be working ok for now.
73, Curt KB5JO
----- Original Message -----
From: "Mike Hyder -N4NT-" <Mike_N4NT@charter.net>
To: "Ten-Tec Reflector" <tentec@contesting.com>; <rhulett1@consolidated.net>
Sent: Tuesday, March 22, 2011 9:04 AM
Subject: [TenTec] Fw: Omni C transmit off frequency
> My manual shows the control of which I speak on page 3-56 on the 80708
> Control Board. It is R-16. The manual says, "Trimpot R16 is adjusted to
> a
> value equal to the center position voltage of the OFFSET control, in
> essence
> the voltage representing NO offset."
>
> ----- Original Message -----
> From: "Mike Hyder -N4NT-" <Mike_N4NT@charter.net>
> To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
> Sent: Tuesday, March 22, 2011 8:41 AM
> Subject: Re: [TenTec] Omni C transmit off frequency
>
>
>> Two things come to mind:
>>
>> 1. An internal potentiometer used to set the offset when the OT control
>> is
>> turned off.
>>
>> 2. The carrier oscillator, set by adjustment of three separate trimmer
>> capacitors. (I'm not sure this could even be the problem, but it did come
>> to
>> mind).
>>
>> I'd suggest finding and adjusting #1 first because it requires no
>> instruments to accomplish and it is probably the culprit.
>>
>> 73, Mike N4NT
>>
>> ----- Original Message -----
>> From: "Hulett, Russell" <rhulett1@consolidated.net>
>> To: <tentec@contesting.com>
>> Sent: Monday, March 21, 2011 9:21 PM
>> Subject: [TenTec] Omni C transmit off frequency
>>
>>
>>> Am back to working with "mint" Omni C I foolishly bought. After tuning
>>> onto a sideband frequency, my transmitted signal is off frequency for
>>> the
>>> other op, as if RIT were on though it is not. Any ideas?
>>>
>>> 73, Curt KB5JO
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|