Unless your not going to use the Centurion for an extended length of
time, you shouldnt turn off the amp. The wear on the tubes turning them
on and off is far greater than leaving them on. Once I turn mine on for
the evening it is on until I quit or leave for a long time....
----- Original Message -----
From: Carter Grabarczyk <k8vt@ameritech.net>
To: gjn <gjn@mail.image.dk>
Cc: Ten-Tec reflector <tentec@contesting.com>
Sent: Sunday, December 12, 1999 9:16 AM
Subject: Re: [TenTec] Centurion start-up time
>
> gjn wrote:
> >
> In between my turns I turn off the power switch.
> >
> > Question: For how long after switching the power switch on again should
I
> > wait untill driving it?
>
> Gunner,
> I believe that with the 3-500Zs, you may drive it almost
> instantaneously, or certatainly within 1 or 2 seconds (as soon as the
> filaments are at full brilliance). However, why do you want to do
> this??? The inrush/startup filament current is MUCH, MUCH more difficult
> on the tubes and greatly REDUCES the life of the tubes compared to just
> leaving them on for the duration of the QSO.
>
> 73/Carter/K8VT
> a happy Omni 6+/Centurion owner
>
> --
> FAQ on WWW: http://www.contesting.com/tentecfaq.htm
> Submissions: tentec@contesting.com
> Administrative requests: tentec-REQUEST@contesting.com
> Problems: owner-tentec@contesting.com
> Search: http://www.contesting.com/km9p/search.htm
>
>
--
FAQ on WWW: http://www.contesting.com/tentecfaq.htm
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|