Hmmm, well I don't know what bond paper is. Perhaps what I call Emery
paper.
But it is very difficult to get anything down in there.
Picture this: you have a 1/5" tube about an inch long, closed at one end.
Then you have a 1/16" pin running up the middle. It is very tight quarters
for doing anything.
Actually my idea was to soak a toothpick in contact cleaner, then flatten it
just a little with a pair of pliers, then run the toothpick up and down the
center pin, and around the inside walls of the barrel.
73 - Rick, DJ0IP
(Nr. Frankfurt am Main)
-----Original Message-----
From: TenTec [mailto:tentec-bounces@contesting.com] On Behalf Of K8JHR
Sent: Thursday, July 17, 2014 7:20 AM
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] Scout has vy low Pwr out on some bands
Use a piece of scratchy bond paper... just tear a corner off your Will
and use that... ;-)
OK, he means you should use that type of heavy, course high fiber "bond"
paper. The good stuff has no acid in it.
------------------ K8JHR ------------------------
On 7/16/2014 5:59 PM, Rick - DJ0IP / NJ0IP wrote:
> Sorry Stuart, I have no idea what you are talking about.
> I do have some stiff paper that I can try.
> That may actually prove to be the best idea.
______________________________________________
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|