Bill,
You'll want to look at the preamplifier section of the radio. Although I
have to admit it will be a challenge until you call the fellows in
Sevierville and order up their outstanding owners manual.
By the way... the rig works best (and that means better than virtually any
multi-thousand buck rig from our friends in Japan) with the preAmp OFF, AGC
OFF, audio UP, and RF gain turned down. No foolin'
73! =paul= W8KC
Collector of Ten*Tecs and other fine plastics.
Visit the Virtual Ten*Tec Museum at http://mywebpages.comcast.net/w8kc
----- Original Message -----
From: "William Evans" <bevans@starband.net>
To: <tentec@contesting.com>
Sent: Monday, October 27, 2003 8:17 PM
Subject: [TenTec] 560 Problem
>
> I purchased a 560 (Corsair One) recently, and do not have the manual to
> go with it. Everything seems to work except for the receive RF
> amplifier. When I push in the knob and the RF amp light comes on, the
> signals are attenuated about 10-15 S units. Instead of amplified, the
> signals are attenuated to the point of not hearing anything but hiss.
> Does anyone have any suggestions of where to look? Any help will be
> greatly appreciated.
>
> w4ish
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|