try changing the com port until you find the correct one . that is what I
had to do . all the best . John kb2huk
----- Original Message -----
From: "Stan Dicks" <w4ag@mindspring.com>
To: "'Discussion of Ten-Tec Equipment'" <tentec@contesting.com>
Sent: Friday, April 27, 2007 11:56 AM
Subject: Re: [TenTec] Flash update not working
> John,
>
> Thanks for the tip, but it didn't change anything. It gets to the point
> where the transfer should start and then just sits there.
>
> 73, Stan, W4AG
>
> -----Original Message-----
> From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
> On Behalf Of fraz1
> Sent: Friday, April 27, 2007 11:39 AM
> To: Discussion of Ten-Tec Equipment
> Subject: Re: [TenTec] Flash update not working
>
> Stan:
>
> Just for grins, go to the setup box in the flash update program and
> unclick
> on the "stop when errors" box. Then try to download again. Works every
> time for me.
>
> 73 John
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|