It also seems somewhat filter width dependent. Play with the filter width
and mode and you will see small changes.
Carl Moreschi N4PY
121 Little Bell Drive
Bell Mountain
Hays, NC 28635
----- Original Message -----
From: "fraz1" <fraz1@bellsouth.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Saturday, May 12, 2007 1:18 PM
Subject: Re: [TenTec] 2.060b S-Meter "0"
> Grant:
>
> I noticed the same thing, almost immediately. Not a biggie at this end.
>
> John K4NP
> ----- Original Message -----
> From: "Grant Youngman" <nq5t@tx.rr.com>
> To: "'Discussion of Ten-Tec Equipment'" <tentec@contesting.com>;
> <orion565@yahoogroups.com>
> Sent: Saturday, May 12, 2007 12:12 PM
> Subject: [TenTec] 2.060b S-Meter "0"
>
>
> > I've discovered today that the s-meter "zero" position on my orion with
> > 2.060b installed is about S-1.5. With 1.3xx software installed it sites
> > dead on S-1 where it is supposed to.
> >
> > Can anyone with a v2 Orion and 2.060b confirm where the S-meter sits
with
> > no
> > signal no antenna?
> >
> > Thanks ... Grant/NQ5T
> >
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> >
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|