If the 706 has the same board as the 705 there is a switch to select bias
from the rig or an internal battery. Do you have the switch set properly.
Could there be a wiring problem in the mic or connector?
GL & 73, Bill - K6WLM
----- Original Message -----
From: "Paul K." <hglent@frii.com>
To: <tentec@contesting.com>
Sent: Wednesday, July 22, 2009 6:52 AM
Subject: [TenTec] Weak Output from 706 Microphone and your recommendations.
>I have a model 706 desk mic that has lost most of the out put. It still
> has output, but I must run the Mic Gain on the Orion 1 up to 50 to 75,
> and it will drive the VOX marginally. I have replaced the element with
> one I purchased from Ten Tec. Still the out put level is very low. I
> just checked with Paul Clinton in the Service Department on purchasing a
> new board. He tells me the boards are not available, but he could run
> it through the shop at $60.00 an hour. Probably in the neighborhood of
> $120.00 for the repair.
> So, the question is, has any one had this experience with the 706, and
> if so what was the fix? Secondly, I would like recommendations on a
> replacement mic for the Orion 1. I seldom us SSB as I op mostly CW, but
> when I do op SSB I like a desk mic. So what are the recommendations?
>
> Paul K
> TNX ... es ... 73S ... de ... WA0BAG
> DIT .. ..DIT
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|