Hi Alfred,
Please take a look at next link.
http://www.mods.dk/mods.php3?radio=icom&model=ic-sm2&selectid=2383#2383
vy73's Gerard / PA1TX
----- Original Message -----
From: "Alfred Heyden" <alfred.heyden@t-online.de>
To: "TenTec List" <tentec@contesting.com>
Sent: Saturday, October 18, 2003 10:08 PM
Subject: [TenTec] Paragon II and Icom Mike SM 6
> Hello dear TenTec list members,
> I'm Alfred, DL2JR, near Bonn/Germany.
> Would like to connect a SM 6 mike from Icom with my Paragon.
> But unfortunetly I don't have a schematic of the mike for wiring
> the plug to use it with the Paragon. Can anyone of you enlighten
> me
> what colored leads must be wired with what number of the mike
> connector?
>
> There is a little pot at the bottom of the mike marked with Hi
> and Lo.
> Means this an adjustable impedance or is it to adjust a built-in
> pre-amp?
>
> The Paragon manual tells me on page 1-2 that there is 4 volt dc
> at pin nr. 4
> of the mike connector. But I measured 8.5 volts dc. Any comments?
>
> Thanks a lot to you all for your efforts. With regards, Alfred,
> DL2JR
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|