Well, that is a good question. I do have one of those MFJ meters and I will
measure it at the feedpoint. However I think the antenna resonates around
2.8 Mhz. I think I will have to adjust some lengths and heights. It has been
up for ten years or so and feeding it with a 100 W it worked just fine. But
using it QRP I need to get it just right. If I had just a, say, 150 ohm Z
(no reactive components), could I just use a torrid transformer to match the
rigs 50ohm output?
Bill
KB1LG
-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
On Behalf Of Jim WA9YSD
Sent: Wednesday, May 07, 2008 6:21 AM
To: tentec@contesting.com
Subject: [TenTec] Lowest loss matching an antenna for my Argonaut 509
If I read every thing and understood what I have read and what Gerald just
stated, it would be a CURRENT BALUN.
What is your impedance at the feed point at the antenna?
Keep The Faith, Jim K9TF/WA9YSD
____________________________________________________________________________
________
Be a better friend, newshound, and
know-it-all with Yahoo! Mobile. Try it now.
http://mobile.yahoo.com/;_ylt=Ahu06i62sR8HDtDypao8Wcj9tAcJ
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|