Clayton, there is a HUGE difference...
The 961 vs. 962:
One of them regulates the negative side of the PS, the other one regulates
the positive side of the PS.
I don't have the circuits in front of me right now and can't remember which
one was which.
With the 960 and 961, there may be a difference of what max current the
protection circuit triggers.
A lot of water's run under the bridge since I've studied those circuits.
73
Rick, DJ0IP
-----Original Message-----
From: TenTec [mailto:tentec-bounces@contesting.com] On Behalf Of Clayton
Brantley
Sent: Sunday, December 15, 2013 3:51 PM
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] Need a 962 schematic
Mike: The closest I have is a 960. Doubt there is much difference. You
can find that on the "Unofficial TenTec Pages" under power supplies. Bet
the differences are only cosmetic.
Clayton N4EV
On Sunday, December 15, 2013 1:59 AM, Mike Bryce <prosolar@sssnet.com>
wrote:
We'll guys the subject lines tells the story.
Anyone have a PDF of the ten tec 962 power supply? Schematic would be
fine,too.
Mike wb8vge
Sent from my iPad
Knowledge is knowing a tomato is a fruit; Wisdom is not putting it in a
fruit salad.
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|