Allan:
The original message thread was entitled "[TenTec] modifying Omni V for QRP
?" How did it change to "Omni VI? Did you manually enter or change it?
Dan's question related to a modification on the Omni V, not Omni VI. The
stock Omni V is only capable of reducing its power to approximately 15
watts. Paul Clinton, Ten-Tec's Service Manager, advises to replace R46 on
the 9 MHz Filter Board from 100K-ohm to10K-ohm @ 1/4 watt. This brings the
Omni V's minimum output level to QRP.
-Paul, W9AC
-----Original Message-----
From: Allan G. Taylor <ataylor@heracles.llnl.gov>
To: tentec@contesting.com <tentec@contesting.com>
To: <tentec@contesting.com>
Date: Friday, June 12, 1998 12:23 PM
Subject: [TenTec] Modifying OmniVI for QRP
>
>The OmniVI has an infinitely variable power level pot. Why on earth would
you
>want to chop up an OmniVI when one merely needs to crank down a pot level.
Its
>on the front level to boot!!
>
>K7GT
>
>--
>FAQ on WWW: http://www.contesting.com/tentecfaq.htm
>Submissions: tentec@contesting.com
>Administrative requests: tentec-REQUEST@contesting.com
>Problems: owner-tentec@contesting.com
>Search: http://www.contesting.com/km9p/search.htm
>
>
--
FAQ on WWW: http://www.contesting.com/tentecfaq.htm
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|