TenTec
[Top] [All Lists]

[TenTec] Attn Frank with kit 1315: re: 15 meter kit missing page 15

To: <tentec@contesting.com>
Subject: [TenTec] Attn Frank with kit 1315: re: 15 meter kit missing page 15
From: rohre@arlut.utexas.edu (Stuart Rohre)
Date: Fri Apr 18 14:37:22 2003
Subject: 15 meter kit missing page 15


> List members, please excuse this posting for Frank who was missing page
> 15 of his kit manual.  It is not long:

1315 CW transceiver instructions, Manual 74362 (top right front cover)

Assembly page 15:

2-30 Transistor Q14 2N4124
2-31                    Q18 2N4124
2-32                    Q21 2N4124
2-33  Install PNP transistor Q4 type 2N5087
2-34  Install C28, 910 pf polystyrene cap, with red polarity band oriented
as on pcb
2-35  ID two "N80" 150 pf caps clearly marked "N80 151"  Install one as C29
2-36  Install C30, 150 pf "N80" per 2-35
2-37 Install C83, 150 pf NPO, marked "151J"
2-38 Install C37, 0.22mf mylar film (marked 224)
Install these remaining disc capacitors:
2-39 Cap C33, 15 pf
2-40 Cap C101, also 15 pf
2-41 Cap C77, also 15 pf
2-42 Cap C27, 33 pf
2-43 Cap C34, 22 pf
2-44 Cap C31, 39 pf
2-45 Cap C84, 470 pf (marked 471)
2-46 Cap C39, 0.001 mf (marked 102)
2-47 Cap C26, 0.01 mf (marked 103)
2-48 Cap C35, also 0.01 mf
2-49 Cap C78, also 0.01 mf
2-50 Install C38, 10 mf electrolytic. !!+-!!
2-51 Install C36, 33 mf electrolytic. !!+-!!
2-52 Wind 25 turns of #28 enameled wire (green) on a red T-44 toroid core.
The turns should be fairly close together and are counted as 25 passes
through the CENTER of
the core.  Take your time to make sure that no turns cross over each other
and that no kinks are created in the wire.  This is L3, (25 turns #28 on
T-44 core) (drawing of "lifesaver" with wire evenly spread around the core,
both leads come off core same direction.  Conventionally wound toroid).

End of page 15 Assembly steps.

Thanks group,
Stuart K5KVH




<Prev in Thread] Current Thread [Next in Thread>
  • [TenTec] Attn Frank with kit 1315: re: 15 meter kit missing page 15, Stuart Rohre <=