James,
If your voltage is looking a little low, check the resistors on the metering
circuit-board. These seem to gain resistance as they age and therefore the
meter starts to show lower voltages. If you use a DVM and an High-Voltage
probe you will probably find that the HT is fine, change the resistors and
the meter reads like new.
73 de Paul G0CYB
-----Original Message-----
From: Setzler, James M <Setzler_James_M@code80.npt.nuwc.navy.mil>
To: 'tentec@contesting.com' <tentec@contesting.com>
To: <tentec@contesting.com>
Date: 07 November 1997 14:03
Subject: [TenTec] Titan Plate Voltage ?
>What plate voltage (load and no-load) would one expect to see on a
>properly operating relatively late model (5-6 years old) Titan?
>
>thanks & 73 James / k1sd
>
>--
>FAQ on WWW: http://www.contesting.com/tentecfaq.htm
>Submissions: tentec@contesting.com
>Administrative requests: tentec-REQUEST@contesting.com
>Problems: owner-tentec@contesting.com
>Search: http://www.contesting.com/km9p/search.htm
>
--
FAQ on WWW: http://www.contesting.com/tentecfaq.htm
Submissions: tentec@contesting.com
Administrative requests: tentec-REQUEST@contesting.com
Problems: owner-tentec@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|