Just a few questions about downloading and installing new firmware in my Orion
. The manual does not seem to give you any steps other than attaching the
serial cable between the computer and radio.
I have downloaded version 2.062a to my hard drive. I now have 2.060b installed
in the Orion. It was done at Ten Tec. They also made the version 2 hardware
changes.
Questions:
Do you have the radio on or off during the firmware installation? If on do you
have it set to any particular Frequency or mode? How long should this procedure
take? Are there any other steps that I am missing?
I know this seems like simple questions, but I would like to have some idea of
what I am doing before I start. Hi Hi..
73 Art WA8VSJ
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|