I had this problem - both times it was the QSK board. I recently had another
problem but can not remember the symptons - they appeared to another QSK
board but it was the AC/bias board.
FWIW, the afterburner is 10+ years old and never had a relay problem. Over
the years, Ten Tec has comp'd (that means no charge) a few parts. As time
goes on, parts are rarer, supplies decrease, prices increase.
I would consult with Jim at Ten Tec. A QSK board will set you back about $50
if they are still stocked.
Mike
W8TRN
----- Original Message -----
From: "Jim Brown" <k9yc@audiosystemsgroup.com>
To: <tentec@contesting.com>
Sent: Saturday, January 05, 2013 11:03
Subject: Re: [TenTec] Centurion problem
On 1/4/2013 2:08 PM, Doyle wrote:
I have been having problem with my receive not returning after
transmitting. This also happens using either a TS-590 or Omni VI.
Is it possible to clean the relay contacts in the amp? Where is the
relay located?located.
It sounds like a vacuum relay going bad. Contacts are not accessible. You
replace the relay. Ten Tec is VERY expensive as a source of parts, and as
a reapir station. If you have reasonable soldering skills, you can
replace the relay in an hour or two. You'll need to figure out the
manufacturer's part number. Ten Tec used two over the years, KiloVac and
Jennings. They are very different physically, so you need to figure out
which you have. The Jennings is an RJ1A, and sort of looks like a stack of
nickels with leads on top. The KiloVac is long and skinny, with leads
along the body.
You also need to know the coil voltage. I don't know the Centurion, but
Titans use 28Vdc, and the Hercuules II uses 12Vdc. Look at the schematic
to figure out what the voltage is for the low voltage power supply.
These relays are widely available in the $75 range, both as "pulls": from
mdiecal electronics, and new from a company called GigaVac. Alpha now uses
GigaVac, and I've been using them for about five years. GigaVac will sell
them direct to hams at a discount, about $75, and you can also buy them
from a dealer, Max Gain Systems.
73, Jim K9YC
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|