Josh:
Would you like to have the original knob for the Drive control. I have a
couple of them. I was a Ten Tec Dealer at the time of the release of the
Century Series of transceivers and so I have a few parts on hand for the
repair of the units. If you will email me your address I will drop you the
correct knob in the mail.
73,
Jim K4ZM
-----Original Message-----
From: TenTec <tentec-bounces+k4zm=comcast.net@contesting.com> On Behalf Of
Josh Gibbs
Sent: Saturday, June 20, 2020 9:51 PM
To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Century 22
Thanks Bob! Now I understand what the crystal calibrator is all about =)
The rig is really fun to use. Here was a quick SOTA chase that I made
earlier with the C22:
https://www.youtube.com/watch?v=FaJblGDYdS0
You can see I found a nice replacement knob for the one that was destroyed
in shipping. Vetco Electronics in Redmond, WA is such a fun place... they
had the speaker I needed and a nice selection of knobs. Finding some elastic
cord for the tuning dial re-string was a stroke of luck - apparently that
stuff is out of stock everywhere because people are using it to make masks!
It's been a fun project. I really appreciate the advice and files that have
been shared with me on this list.
73,
-Josh WU7H
On Sat, Jun 20, 2020 at 7:33 PM Bob McGraw K4TAX <rmcgraw@blomand.net>
wrote:
> In a short answer....... yep. Expect to make knob skirt changes when
> changing bands.
>
> As to digital displays, when I got my Novice license, if we knew we were
> in the Novice band we were doing great! My bandspread was calibrated 0
to
> 100. As to how many kilo cycles that covered? No one really knew.
> The width of the main tuning dial pointer completely covered the Novice
band.
>
> Bob, K4TAX
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|