Check for connectors that are one pin off.
That is the most frequent thing that happens when folks “reseat connectors”.
Gary
W0DVN
> On May 24, 2017, at 8:10 PM, Michael Marx <sndtubes@xxxxxxxxxxxxxxx> wrote:
>
> Hi guys,
>
> Unfortunately, my newly acquired Omni 6+ just “blew up”. It was working
> fine. Then I noticed the display was a missing digits and segments. I
> figured I just needed to re-seat the connectors which I did. When I turned
> it back on, the dial lights flashed up brightly and then dimmed. At that
> point, all of the LED’s on the panel were lit and nothing else. Any
> suggestions on what I should do now?
>
> 73
> Mike WB0SND
>
>
> Michael Marx
> sndtubes@xxxxxxxxxxxxxxx
> 636-939-9190
>
>
>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@xxxxxxxxxxxxxx
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@xxxxxxxxxxxxxx
http://lists.contesting.com/mailman/listinfo/tentec
|